Description

MiTicA is composed by five 3d printed teeth and they reproduce five different complications as pulp capping, floor perforation, open apex, root perforation and micro apical surgery. All the kit is not intended single use and can be cleaned at the end of training session. MTA is the perfect material to use here, but also bioceramics are welcomed.

Pulp capping: place your repair material inside a small hole, positioned by side inside pulp chamber Floor Perforation: place fibrine first and repair material after inside a perforation positioned in the middle of the floor. Be sharp, the challenge is also to avoid placement of the material inside root canals.

Open Apex: try to perform a perfect direct apical plug, placing a fibrine support over the apex, under red mark and after the repair material. Three millimeters are enough, but remember that this apex has a diameter around 200.

Root Perforation: this is a real challenging situation! Try the sandwich technique described by Styleitaliano Endodontics and place your repair material after a short gutta-percha cone. Take your time, is the most difficult tooth.

Micro Apical Plug: fill directly Mesial root and isthmus or distal root with your preferred material. If you want to try the cut of the apex work on palatal root and fill it!